#08/26 Light brown / Blonde Russian Micro Bead streaks 21 inch

For an average full head 100pc-150pc will be needed.

100pc if your hair is thin to medium and has some length already.

150pc will be needed if your hair is short or very thick.

I-Tip Stick hair extensions are part of our micro bead hair extension range and weigh 1 gram per strand.

No Heat is required.

Includes Silicone lined micro beads ,

Tools needed to install loop threading tool, and extension pliers

They are very strong and can be re-used, washed and heat styled

Preparing Your Hair For The Application Process

Before starting the process of installing the micro beads, you want to make sure that your hair is in good shape. You hair needs to be healthy because hair that is dry, damaged and broken will not take the extensions well at all. This is particularly true for this method as the beads have grooves on the inside that can be damaging to the hair shaft when they are connected to each other.

How To Attach & Tools Required

Before you begin installing your extensions, you should assemble the tools that you will need. You will, of course, need the micro beads and the bead clamp tool as well as a loop tool. You may also want to have a tail comb and several hair clips.

Start with hair that is clean and dry. Comb it well to make sure that it is tangle free. Tangles can make it very difficult to install the extensions. It can also cause damage to your hair if you try to install extensions when your hair in tangled.

Preparing The Site

To begin installation, part your hair straight down the middle, from front to back, using the tail comb. Next, part your hair from ear to ear so that you have four sections. Make sure that each part is perfectly straight.

Use a clip to hold the hair in each section and keep the parts straight.

Using The Micro Loop Tool

Slide the micro beads on the loop tool. In one section of hair, use your comb to catch up a thin piece of hair. All of the hair strands should be in very close proximity of each other. Do not make the piece too big or it won’t fit in the micro bead. If it is too small, the bead will be ill fitting. Try to get it as close to the size of the bead as possible.

Using the loop tool, slip the ultra light blonde micro bead over the piece of hair so that it is one quarter to one half inch from the roots. Gently slide the extension into the bead. Use the bead tool to clamp the micro bead, tightening it around the hair section and extension, securing it. The clamped bead will be flat. Continue with the other sections of hair.

It is important to note that you should never install extensions at the bangs, temples or on the top of the head. Only install at the lower portion of the crown, no higher.